 |
 |
 |
|
|
|
[Sponsors] | ||||
June 2, 2018, 13:07
|
Far Field Boundary conditions
|
#1 |
|
Member
João Lourenço
Join Date: Jan 2017
Posts: 32
Rep Power: 9  |
Hello everyone,
In SU2, It is possible to select a far-field characteristic-based condition on the far-field markers for the domain in the boundary conditions. What is the meaning of this? The pressure or velocity is prescribed in the domain boundaries? When I select the marker heat flux for my airfoil I know the mean: no slip conditions for velocty and heat flux. But I far field case what is the phisical meaning? Thanks Joao Lourenco |
|
|
|
|
|
July 2, 2018, 13:16
|
|
#2 |
|
Member
Amit
Join Date: May 2013
Posts: 85
Rep Power: 13 |
Characteristics based boundary conditions (Riemann Invariants). U can check few cfd books like by Blajek or check online, lot of literature is available.
Basically information propagation into or out of domain based on flow conditions next to the boundaries. Last edited by aero_amit; July 2, 2018 at 22:32. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 11:00 |
| Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 02:27 |
| Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 05:39 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
1Likes
Linear Mode
