Pressure probes

sirius · June 16, 2014, 09:42

What is the procedure to put pressure probes in the flow field and at the boundary in SU2? Thanks.

economon · June 24, 2014, 21:19

Hi,

SU2 will output the pressure on the surface of any specified markers and then also in the volume mesh. This information is typically found in the surface_flow.dat/flow.dat or surface_flow.vtk/flow.vtk files (Tecplot/ParaView). You could, of course, add print statements to the code to output the current pressure at one of the nodes, but there is not a built in interpolation or probe function at the moment for outputting the pressure at arbitrary (x,y,z) locations. We typically do this as a post-processing step in a visualization package.

Hope this helps,
Tom

Bullseye · January 25, 2016, 07:00

Is this function now implemented?

June 16, 2014, 09:42	Pressure probes	#1
sirius New Member Sirius Join Date: Jun 2014 Posts: 4 Rep Power: 12	What is the procedure to put pressure probes in the flow field and at the boundary in SU2? Thanks. EMolina and chliu like this.

January 25, 2016, 07:00		#3
Bullseye New Member Join Date: Dec 2012 Posts: 7 Rep Power: 14	Is this function now implemented? Haupei likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pressure Driven Supersonic Flow in Converging-Diverging Nozzle	cdm	OpenFOAM Running, Solving & CFD	7	August 28, 2019 02:37
How to get the total pressure in the UDF?	zgzhai	Fluent UDF and Scheme Programming	3	September 24, 2018 17:12
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
replacing of shock tube high pressure part with a boundary condition for low pressure	immortality	Main CFD Forum	0	May 2, 2013 14:30
Unsteady pressure differential between inlet and outlet of the pipe for single phase	joshi20h	FLUENT	0	September 26, 2012 13:41

June 24, 2014, 21:19		#2
economon Super Moderator Thomas D. Economon Join Date: Jan 2013 Location: Stanford, CA Posts: 271 Rep Power: 14	Hi, SU2 will output the pressure on the surface of any specified markers and then also in the volume mesh. This information is typically found in the surface_flow.dat/flow.dat or surface_flow.vtk/flow.vtk files (Tecplot/ParaView). You could, of course, add print statements to the code to output the current pressure at one of the nodes, but there is not a built in interpolation or probe function at the moment for outputting the pressure at arbitrary (x,y,z) locations. We typically do this as a post-processing step in a visualization package. Hope this helps, Tom