How do I create probes so to determine the wave height at that point?

gwenolaa · July 14, 2021, 09:09

Hi!

I need help with the software. Currently I am trying to run a simulation where a ship is moving along the beach. How do I create probes along the edge of the beach so to determine the wave height when the ship passes that point?

Could someone show me step by step on what to create, select etc because I am very new to this!

Thank you.

[IMG] https://drive.google.com/file/d/1Fb9...ew?usp=sharing [/IMG]

Nikpap · July 20, 2021, 08:00

Right click on Derived Parts > New Part > Probe > Point

ping · July 20, 2021, 08:05

it could be more useful to use a vertical line probe or the intersection of two section planes so you can plot the height continuously since a point probe will give you just a yes/no reading

July 14, 2021, 09:09	How do I create probes so to determine the wave height at that point?	#1
gwenolaa New Member Join Date: Jul 2021 Posts: 1 Rep Power: 0	Hi! I need help with the software. Currently I am trying to run a simulation where a ship is moving along the beach. How do I create probes along the edge of the beach so to determine the wave height when the ship passes that point? Could someone show me step by step on what to create, select etc because I am very new to this! Thank you. [IMG] https://drive.google.com/file/d/1Fb9...ew?usp=sharing [/IMG] Last edited by gwenolaa; July 14, 2021 at 09:13. Reason: add picture

July 20, 2021, 08:05		#3
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	it could be more useful to use a vertical line probe or the intersection of two section planes so you can plot the height continuously since a point probe will give you just a yes/no reading Aeronautics El. K. likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
interFoam wave propagation and explosion of Courant number and residuals	ChiaraViola	OpenFOAM Running, Solving & CFD	1	June 26, 2019 06:36
OpenFoam "Permission denied" and "command not found" problems.	iyidaniel@yahoo.co.uk	OpenFOAM Running, Solving & CFD	11	January 2, 2018 07:47
[GAMBIT] How to plot S pipe	mariam.sara	ANSYS Meshing & Geometry	36	November 7, 2013 16:22
Actuator disk model	audrich	FLUENT	0	September 21, 2009 08:06
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19

July 20, 2021, 08:00		#2
Nikpap New Member Nikolaos Papafilippou Join Date: Apr 2019 Posts: 25 Rep Power: 7	Right click on Derived Parts > New Part > Probe > Point