 |
 |
 |
|
|
|
[Sponsors] | ||||
November 19, 2014, 08:50
|
Picture doesn't appear
|
#1 |
|
Senior Member
Paulo Vatavuk
Join Date: Mar 2009
Location: Campinas, Brasil
Posts: 200
Rep Power: 18  |
Hi,
In my previous post (see bellow) I tried to add a picture from a dropbox link and it didn't work. What should I do so that the picture appears in the post? http://www.cfd-online.com/Forums/ope...tml#post519741 Best Regards, Paulo Last edited by vatavuk; November 19, 2014 at 09:58. |
|
|
|
|
|
November 20, 2014, 14:02
|
|
#2 |
|
Administrator
Peter Jones
Join Date: Jan 2009
Posts: 682
Rep Power: 10 |
With dropbox you must use the dl.dropbox.com address to display an image. Using the www.dropbox.com address does not point directly to the image but to a webpage with the image on, so that does not work. To include your image I would write:
[IMG]http://dl.dropbox.com/s/ufrbjwhtxc9ajvp/C.jpg[/IMG] Writing this in your post would show this: 
|
|
|
|
|
|
|
November 21, 2014, 06:54
|
|
#3 |
|
Senior Member
Paulo Vatavuk
Join Date: Mar 2009
Location: Campinas, Brasil
Posts: 200
Rep Power: 18 |
Thank you Pete.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Replay control - save picture | zboud | ANSYS Meshing & Geometry | 13 | June 16, 2016 15:33 |
| How to sketch from a picture in Design Modeler | jatin1990 | ANSYS Meshing & Geometry | 1 | September 30, 2014 03:32 |
| [General] export picture messy problem | chenxizh | ParaView | 1 | January 10, 2014 16:38 |
| Help!!How can I label crank angle on post picture? | Duan J Q | Siemens | 4 | October 10, 2007 09:20 |
| how i can post picture here to show my question? | prayskyer | CFX | 2 | October 8, 2006 07:47 |
1Likes
Linear Mode
