B 92 51 Create 'wavercon.dat' input file

pjoynt · April 21, 2022, 13:02

Hi All,

To generate the "wavercon.dat" input file I need to provide three columns "A", "omega", and "phi". I was wondering if there is a certain format that the rows should be in (ascending omega?). Additionally, I wanted to check the units:

A = Amplitude = meters
omega = Angular Frequency = rad/s
phi = Phase = rad

Thanks!
Patrick

kamath · April 22, 2022, 09:09

You are correct (though it might not be a problem if they are not in ascending order).
Also SI units as you mention.

Just make sure the first row is not 0.0 0.0 0.0
(which can happen from a Matlab FFT output).

April 21, 2022, 13:02	B 92 51 Create 'wavercon.dat' input file	#1
pjoynt New Member PJoynt Join Date: Oct 2021 Posts: 21 Rep Power: 6	Hi All, To generate the "wavercon.dat" input file I need to provide three columns "A", "omega", and "phi". I was wondering if there is a certain format that the rows should be in (ascending omega?). Additionally, I wanted to check the units: A = Amplitude = meters omega = Angular Frequency = rad/s phi = Phase = rad Thanks! Patrick

April 22, 2022, 09:09		#2
kamath Senior Member Arun Kamath Join Date: Nov 2014 Location: Trondheim, Norway Posts: 265 Rep Power: 14	You are correct (though it might not be a problem if they are not in ascending order). Also SI units as you mention. Just make sure the first row is not 0.0 0.0 0.0 (which can happen from a Matlab FFT output). pjoynt likes this. __________________ Arun X years with REEF3D

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 09:46
[foam-extend.org] problem when installing foam-extend-1.6	Thomas pan	OpenFOAM Installation	7	September 9, 2015 22:53
Trouble compiling utilities using source-built OpenFOAM	Artur	OpenFOAM Programming & Development	14	October 29, 2013 11:59
[swak4Foam] funkySetFields compilation error	tayo	OpenFOAM Community Contributions	39	December 3, 2012 06:18
friction forces icoFoam	ofslcm	OpenFOAM	3	April 7, 2012 11:57