[General] ParaView-droplet size distribution

Ricardo1992 · June 8, 2017, 14:07

Hello all,

I am trying to extract the droplet size distribution of an atomisation (3D jet) process using ParaView. Does anybody how may I extract that information?

Regards

Joshua14 · June 9, 2017, 11:07

Ricardo1992,

I am not sure if this is what you are looking for but...

For lagrangian parcels you can use a histogram filter based on Temp, Umag, diameter, or any calculated property. Just make sure only the parcels are active in the 3D viewer.

Hope this helps,
Joshua

Ricardo1992 · August 11, 2017, 11:00

Hello,

Tanks for your replay. The attached figure shows the case that I am undergoing, the jet and the droplet size distribution. The jet I have simulated is similar to the presented in the figure, now I need to know how to extract the droplet information.

Any advice?

tewyme · December 19, 2017, 13:40

Hi,
Could you please tell how did you generate the droplet size distribution? thank you

kk415 · April 1, 2019, 05:21

Hi

I also need to find droplet size distribution. I have not used lagrangian model but interFoam(Eulerian) model. Is there still anyway to get it?

June 8, 2017, 14:07	ParaView-droplet size distribution	#1
Ricardo1992 New Member Carlos Join Date: May 2017 Posts: 16 Rep Power: 9	Hello all, I am trying to extract the droplet size distribution of an atomisation (3D jet) process using ParaView. Does anybody how may I extract that information? Regards Svetlana likes this.

June 9, 2017, 11:07		#2
Joshua14 Member Joshua Join Date: Dec 2016 Location: St. Louis, Missouri Posts: 91 Rep Power: 10	Ricardo1992, I am not sure if this is what you are looking for but... For lagrangian parcels you can use a histogram filter based on Temp, Umag, diameter, or any calculated property. Just make sure only the parcels are active in the 3D viewer. Hope this helps, Joshua joaran likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rosin-Rammler: droplet distribution and obscure parameters	Manuele	FLUENT	0	July 19, 2016 05:25
number density size distribution	Alaska1964	OpenFOAM Running, Solving & CFD	5	June 15, 2016 11:15
Estimating droplet size using CFD	Dana Suwwan	FLUENT	0	November 2, 2012 13:01
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 22:41
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA,	cfdproject	OpenFOAM Meshing & Mesh Conversion	0	April 14, 2009 16:45

December 19, 2017, 13:40		#4
tewyme New Member non Join Date: Nov 2011 Posts: 3 Rep Power: 15	Hi, Could you please tell how did you generate the droplet size distribution? thank you

April 1, 2019, 05:21		#5
kk415 Senior Member krishna kant Join Date: Feb 2016 Location: Hyderabad, India Posts: 133 Rep Power: 10	Hi I also need to find droplet size distribution. I have not used lagrangian model but interFoam(Eulerian) model. Is there still anyway to get it?