|
[Sponsors] |
September 21, 2016, 07:41 |
Export STL from iso-surface
|
#1 |
New Member
changhee kim
Join Date: Feb 2014
Posts: 18
Rep Power: 12 |
I'm using ParaView 5.1.2.
I'm trying to export a iso-surface or threshold from a result into *.stl file. I add a figure below. Best regards, Changhee Kim |
|
September 21, 2016, 08:10 |
|
#2 |
Member
Join Date: May 2014
Posts: 40
Rep Power: 12 |
Hey, that's how I usually do it:
Iso-surface:
Threshold:
Best Phil |
|
September 21, 2016, 20:18 |
|
#3 |
New Member
changhee kim
Join Date: Feb 2014
Posts: 18
Rep Power: 12 |
Thank you so much!!
|
|
February 9, 2017, 16:28 |
|
#4 |
New Member
FC
Join Date: Feb 2017
Posts: 1
Rep Power: 0 |
I am new to tecplot. I don't know how to get this isosurface filter/ triangulate filter option. Is there a dropdown box I am missing?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh cannot achieve smooth surface from stl | alex::cfd | OpenFOAM Meshing & Mesh Conversion | 2 | October 22, 2018 12:39 |
[mesh manipulation] extrudeMesh from STL Surface | TRT | OpenFOAM Meshing & Mesh Conversion | 1 | March 26, 2018 07:15 |
[snappyHexMesh] Snap Precision to a STL Surface | malaboss | OpenFOAM Meshing & Mesh Conversion | 16 | July 26, 2013 01:44 |
[Workbench] Meshing and export mesh from STL geometry | alerfreire | ANSYS Meshing & Geometry | 0 | March 26, 2013 09:25 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |