fluid/fluid interface type

fluent_beginner · May 13, 2011, 03:21

Hello,

I would like to know if there is any other interface type in OpenFoam instead of directMappedWall. DirectMappedWall will be set as default after executing splitMeshRegions. I think this can only be used for a solid/solid or solid/fluid interface. What kind of type should be used for a fluid/fluid interface? Is there any possibility to get to know all types which can be set maybe by setting a dummy?

Thank you

samiam1000 · May 3, 2012, 11:33

Dear Foamer,

have you solved it?

And in which file do you define the directMappedWall interface?

And which is the new one?

Thanks a lot,

Samuele

May 13, 2011, 03:21	fluid/fluid interface type	#1
fluent_beginner New Member Join Date: Jul 2010 Posts: 3 Rep Power: 16	Hello, I would like to know if there is any other interface type in OpenFoam instead of directMappedWall. DirectMappedWall will be set as default after executing splitMeshRegions. I think this can only be used for a solid/solid or solid/fluid interface. What kind of type should be used for a fluid/fluid interface? Is there any possibility to get to know all types which can be set maybe by setting a dummy? Thank you samiam1000 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
boundary conditions for simpleFoam calculation	foam_noob	OpenFOAM Running, Solving & CFD	8	July 1, 2015 09:07
Pressure instability with rhoSimpleFoam	daniel_mills	OpenFOAM Running, Solving & CFD	44	February 17, 2011 18:08
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50

May 3, 2012, 11:33		#2
samiam1000 Senior Member Samuele Z Join Date: Oct 2009 Location: Mozzate - Co - Italy Posts: 520 Rep Power: 19	Dear Foamer, have you solved it? And in which file do you define the directMappedWall interface? And which is the new one? Thanks a lot, Samuele