Problem running an example

uzzi · October 4, 2018, 20:32

Hello,

I have created an example using the airFoil2D example from OpenFoam and created my own geometry. For some reason that is far from my knowledge now, the simulation does not run with simpleFoam.

If you have time, the files are here:

If you are an expert, would you be so kind to take a look at it and tell me where the problem is?

Thanks a lot...

Francisco

Lorena2fdez · October 5, 2018, 03:38

Hi Francisco,

I have tried to run your case. All the boundaries in constant/polyMesh/boundary are defined as a patch, some of them must be defined with the type wall or empty. Also, there is a boundary "airfoil" not included in the 0 time fields. freestreamVelocity and freestreamPressure aren't in my current OpenFoam version, however freestream yes it is. Even this corrections must be another mistake, simpleFoam run but finalize with an error at time 15.

I hope it helps you.

Greetings,
Lorena

October 4, 2018, 20:32	Problem running an example	#1
uzzi New Member Francisco Pantano Join Date: Oct 2018 Posts: 3 Rep Power: 8	Hello, I have created an example using the airFoil2D example from OpenFoam and created my own geometry. For some reason that is far from my knowledge now, the simulation does not run with simpleFoam. If you have time, the files are here: If you are an expert, would you be so kind to take a look at it and tell me where the problem is? Thanks a lot... Francisco

October 5, 2018, 03:38		#2
Lorena2fdez New Member Lorena Fernández Fernández Join Date: May 2016 Location: Spain Posts: 21 Rep Power: 10	Hi Francisco, I have tried to run your case. All the boundaries in constant/polyMesh/boundary are defined as a patch, some of them must be defined with the type wall or empty. Also, there is a boundary "airfoil" not included in the 0 time fields. freestreamVelocity and freestreamPressure aren't in my current OpenFoam version, however freestream yes it is. Even this corrections must be another mistake, simpleFoam run but finalize with an error at time 15. I hope it helps you. Greetings, Lorena uzzi likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem About Running Fluent In Linux	mitra	FLUENT	18	June 20, 2019 03:11
Problem running angledDuct tutorial of porousSimpleFoam	Anindya1	OpenFOAM Running, Solving & CFD	0	January 24, 2016 11:02
Non- stop running for a time-dependent heat source problem	Asghari_M	OpenFOAM Programming & Development	1	May 11, 2015 06:13
problem with running in parallel	dhruv	OpenFOAM	3	November 25, 2011 06:06
Kubuntu uses dash breaks All scripts in tutorials	platopus	OpenFOAM Bugs	8	April 15, 2008 08:52