|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Jue Wang
Join Date: Apr 2014
Posts: 23
Rep Power: 12 ![]() |
Hi, FOAMers,
I recently ran an airpocket movement simulation with interFoam but just noticed the compressibility does matter. I know there's a compressibleInterFoam solver, as well as a compressibleInterDyMFoam. The problem is there's no real RAS model tutorial for both the compressible solvers while the RAS tutorial of compressibleInterDyMFoam is actually a laminar case. Does someone have done such simulation with RAS model for either compressibleInterFoam or compressibleInterDyMFoam? How should I setup the boundary conditions and edit the fvSchemes and fvSolution files? Thanks a lot. Joe |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Liz
Join Date: Apr 2020
Location: Germany
Posts: 10
Rep Power: 6 ![]() |
Hi everyone,
I know, that this post is a little bit old but in case someone is wondering about it, maybe this could help: http://www.cfdyna.com/Home/of_multiPhase.html |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Coupling RPI wall boiling model with population balance model in Fluent | softice2006 | Fluent Multiphase | 1 | April 19, 2023 02:09 |
[OpenFOAM-2.1.0] kklOmega RAS Turbulence Model (low Re) | alquimista | OpenFOAM Running, Solving & CFD | 64 | June 17, 2016 14:39 |
coalChemistryFoam: "Foam::error::printStack(Foam::Ostream&) at ??:?" | musabai | OpenFOAM Running, Solving & CFD | 2 | February 20, 2015 14:07 |
change RAS model | Jackie Chen | OpenFOAM | 2 | February 26, 2014 05:14 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |