|
[Sponsors] |
July 11, 2011, 19:00 |
Ignition point in reactingFoam?
|
#1 |
Member
|
Hi, I trying to simulate a non premixed flame (diffusive flame) in openFoam, first I try with fireFoam but I not understand very well this solver, then I decided to use reactingFoam, I made several tests with ignition by autoignition, now I want to make a case with a piloted ignition but I am not sure if using reactingFoam is possible to define an ignition point like in XiFoam, If any one know how I can do it, I was very thankful with some advice.
thanks Felipe
__________________
Felipe G |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ignition in reactingFoam | pas32 | OpenFOAM Programming & Development | 4 | August 13, 2014 10:00 |
reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 18:29 |
Spark Ignition at two point ? | ngoctm | CFX | 0 | February 13, 2009 03:59 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |