Adding mass source term to reactingFoam

Bahram · April 30, 2014, 11:21

Hi Foamers

I would like to add a mass source term to the reactingFoam. I defined my_source in the createFields.
I edited my equations like this:
rhoEqn == my_source

YEqn == my_source

PEqn == my_source

how should I modify my energy and momentum equations(EEqn, UEqn)?

Any help would be greatly appreciated.

Regards

Bahram

Bahram · April 30, 2014, 13:21

Isn't anybody interested in this topic?

Bahram · May 2, 2014, 06:58

can anybody help??????????????

dkxls · May 2, 2014, 07:18

Take a look at the reactingParcelFoam or sprayFoam solvers. These solvers have source terms in the conservation equations from the Lagrangian phase.

Bahram · May 2, 2014, 09:15

Thanks for your help, I'll check them...

April 30, 2014, 11:21	Adding mass source term to reactingFoam	#1
Bahram New Member Bahram Haddadi Join Date: Feb 2014 Location: Vienna, Austria Posts: 20 Rep Power: 12	Hi Foamers I would like to add a mass source term to the reactingFoam. I defined my_source in the createFields. I edited my equations like this: rhoEqn == my_source YEqn == my_source PEqn == my_source how should I modify my energy and momentum equations(EEqn, UEqn)? Any help would be greatly appreciated. Regards Bahram mmartin likes this.

May 2, 2014, 07:18		#4
dkxls Senior Member Armin Join Date: Feb 2011 Location: Helsinki, Finland Posts: 156 Rep Power: 19	Take a look at the reactingParcelFoam or sprayFoam solvers. These solvers have source terms in the conservation equations from the Lagrangian phase. BlnPhoenix likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error	FerdiFuchs	OpenFOAM Community Contributions	27	April 16, 2014 16:14
[swak4Foam] swak4Foam-groovyBC build problem	zxj160	OpenFOAM Community Contributions	18	July 30, 2013 14:14
Adding an explicit source term in the UEqn()	Anne Lincke	OpenFOAM Running, Solving & CFD	0	June 25, 2013 13:19
[swak4Foam] build problem swak4Foam OF 2.2.0	mcathela	OpenFOAM Community Contributions	14	April 23, 2013 14:59
friction forces icoFoam	ofslcm	OpenFOAM	3	April 7, 2012 11:57

April 30, 2014, 13:21		#2
Bahram New Member Bahram Haddadi Join Date: Feb 2014 Location: Vienna, Austria Posts: 20 Rep Power: 12	Isn't anybody interested in this topic?

May 2, 2014, 06:58		#3
Bahram New Member Bahram Haddadi Join Date: Feb 2014 Location: Vienna, Austria Posts: 20 Rep Power: 12	can anybody help??????????????

May 2, 2014, 09:15		#5
Bahram New Member Bahram Haddadi Join Date: Feb 2014 Location: Vienna, Austria Posts: 20 Rep Power: 12	Thanks for your help, I'll check them...