 |
 |
 |
|
|
|
[Sponsors] | ||||
December 1, 2011, 14:16
|
2D snappyHexMesh with layers
|
#1 |
|
Member
Join Date: Nov 2010
Posts: 41
Rep Power: 16  |
I've tried to make a 2D snappyHexMesh using the accepted workaround, i.e. using extrudeMesh. This works fine, but only if you dont have layers (addLayers). Since the layers peter out towards the extrusion patch (wall), the extruded mesh does not include any of the layers, but only the castellated mesh...
The first image shows a slice of the 3D mesh after snappyHexMeshing. All good. The second image shows how the layers are tapered out towards the extrusion patch. Which is the problem. Third image shows the result after extrusion. No layers! Is it possible somehow to extrude from a slice (image 1) of the 3D snappyHexMesh, thus allowing layers to be present in the extruded 2D Mesh?? Or another way? Any ideas? |
|
|
|
|
|
December 2, 2011, 13:53
|
|
#2 |
|
Member
Join Date: Nov 2010
Posts: 41
Rep Power: 16 |
actually, all you need to do is set the boundary conditions of the sidewalls to empty then the layers go all the way.
|
|
|
|
|
|
|
May 27, 2013, 13:00
|
snap
|
#3 |
|
Member
Join Date: Oct 2012
Posts: 47
Rep Power: 14 |
hello
i want to mesh a 2d airfoil in sanappy but it dont snap can any one help me please? |
|
|
|
|
|
 |
| Tags |
| addlayers, extrudemesh, snappyhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Old and busted: snappyHexMesh and add layers with edges | Siassei | OpenFOAM Meshing & Mesh Conversion | 6 | August 14, 2018 19:33 |
| [snappyHexMesh] Triangular elements in boundary layers generated by snappyHexMesh | mike.franky | OpenFOAM Meshing & Mesh Conversion | 0 | June 3, 2018 10:46 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
| [snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 03:32 |
| [snappyHexMesh] SnappyHexMesh doesn't succeed in adding several layers | eti0123456789 | OpenFOAM Meshing & Mesh Conversion | 5 | April 9, 2013 03:36 |
2Likes
Linear Mode
