 |
 |
 |
|
|
|
[Sponsors] | ||||
May 4, 2017, 18:52
|
snappyHexMesh in ParaView
|
#1 |
|
New Member
Svetlana
Join Date: May 2017
Posts: 2
Rep Power: 0  |
Hello!
I build adaptive hexahedral mesh in OpenFOAM with the help of utility snappyHexMesh. And then, when I open the results in ParaView, I see strange oblique lines. Does this mean that the mesh data was incorrectly transferred from OpenFOAM to ParaView, or ParaView can't visualize octree meshes? |
|
|
|
|
|
May 4, 2017, 22:57
|
|
#2 |
|
Senior Member
Join Date: Aug 2013
Posts: 407
Rep Power: 16 |
Hi,
Is the "Decompose Polyhedra" option selected in the list of available options for the mesh? That might explain the lines that you see. Cheers, Antimony |
|
|
|
|
|
|
May 5, 2017, 04:05
|
|
#3 |
|
New Member
Svetlana
Join Date: May 2017
Posts: 2
Rep Power: 0 |
Thank you! The problem really was that this option was enabled.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] snappyHexMesh - can't open mesh in ParaView | tfigueiro | ParaView | 0 | June 11, 2015 20:05 |
| [snappyHexMesh] Problems after snappyHexMesh with paraview | andreas0209@hotmail.com | OpenFOAM Meshing & Mesh Conversion | 10 | February 23, 2015 12:00 |
| paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 22:41 |
| [snappyHexMesh] Paraview and snappyhexmesh help needed | basilwatson | OpenFOAM Meshing & Mesh Conversion | 0 | November 9, 2009 10:13 |
| [snappyHexMesh] snappyhexmesh: addLayersControls and paraview | wizard1301 | OpenFOAM Meshing & Mesh Conversion | 6 | March 26, 2009 05:57 |
2Likes
Linear Mode
