 |
 |
 |
|
|
|
[Sponsors] | ||||
February 4, 2015, 06:21
|
Creating circular patch
|
#1 |
|
New Member
Warning
Join Date: Jan 2015
Posts: 15
Rep Power: 11  |
 Hi Foamers I am new to Open FOAM, i am trying to create a geomentry in which one of the side i need a circular patch but i tried using toposet and i ended up with rectangular patches,the geomentry is basically like circular hole in wall,is there any other way to do it ? For your references i have attached the image Can anybody give me any advice how to create it. |
|
|
|
|
|
February 6, 2015, 05:53
|
|
#2 |
|
New Member
Warning
Join Date: Jan 2015
Posts: 15
Rep Power: 11 |
hey guys i found the solution, you can find the reference here http://www.cfd-online.com/Forums/ope...m-toposet.html
|
|
|
|
|
|
 |
| Tags |
| mesh, openfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| [Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 11:45 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| [blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 13:46 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
1Likes
Linear Mode
