|
[Sponsors] |
Pointwise Mesh and Block Regarding Turbomachinery case |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 19, 2021, 05:15 |
Pointwise Mesh and Block Regarding Turbomachinery case
|
#1 |
New Member
Wang Li
Join Date: May 2021
Location: China
Posts: 18
Rep Power: 5 |
Hi ,is there anyone who is familiar with POINTWISE to generate block for rotating impeller in case of radial Pump.
here is example in given picture Last edited by Hanvo; August 19, 2021 at 05:20. Reason: words correction |
|
August 19, 2021, 17:19 |
|
#2 |
Senior Member
Tom-Robin Teschner
Join Date: Dec 2011
Location: Cranfield, UK
Posts: 211
Rep Power: 16 |
Normally I would suggest using the customer support for these sort of questions which are really helpful but I guess this is not an option for you since your customer ID is SolidSQUAD?!
|
|
August 20, 2021, 03:12 |
|
#3 |
New Member
Wang Li
Join Date: May 2021
Location: China
Posts: 18
Rep Power: 5 |
Ok thanks for you suggestions.
|
|
Tags |
ponitwise, pump simulation, turbomachines |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
foam-extend-4.1 release | hjasak | OpenFOAM Announcements from Other Sources | 19 | July 16, 2021 06:02 |
[mesh manipulation] How to write cellSet for different regions in constant/polyMesh/sets | Struggle_Achieve | OpenFOAM Meshing & Mesh Conversion | 3 | June 17, 2019 10:29 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
[blockMesh] Mixer mesh - negative volume problem | jadtwo | OpenFOAM Meshing & Mesh Conversion | 2 | November 6, 2014 17:37 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 03:58 |