[Hertzel]

Hi,

i'm trying to make an xy-plot of some velocity profiles in the wake of an ahmed body.
but there seems to be a problem in my journal command.

first i created lines with the names line1 and line2
the command i'm using is

plot plot yes x_vel_wake no no no z-coordinate no no mean-x-velocity line1 line2

the problem is that fluent keeps requesting for new lines to give in, so if i have some commands in sequence, they are filled in and i get an uncorrect "list".
is there some way to break off the list of surfaces to plot in the TUI?
i didn't find anything about this subject in the fluent manual.

thanks in advance

[Hertzel]

It's ok, i found the solution

a list should be ended with () to close the list

so the command becomes:
plot plot yes x_vel_wake no no no z-coordinate no no mean-x-velocity line1 line2 ()

I'm just putting this online so others shouldn't have the same problems
greetings
Hertzel