Hi,

I have a number of 2D cases where I can't display filled contours. Instead I just get the grid with colour gradients imposed on the lines.

I have seen this message befor, although have had no joy with disabling hardware acceleration as was recommended.

Any suggestions.

Thanks

David

while plotting don't select any boudary entities in the list, just press plot button.

Genius! Thank you.

David

[eslamian]

I have the same problem, i.e. in 2D I cannot show the filled contours instead I get grids. I did not undrestand the answer.

It is in the contour section not plot. Any suggestions? I am stuck.

Thanks
Morteza

[syavash]

Originally Posted by eslamian

I have the same problem, i.e. in 2D I cannot show the filled contours instead I get grids. I did not undrestand the answer.

It is in the contour section not plot. Any suggestions? I am stuck.

Thanks
Morteza

Be sure that no boundaries in the "Surfaces" list be selected in Contour window.

Bests.

[eslamian]

Thanks Syavash. I got it. It worked as you suggested.

[mashiro]

Can you help me?

I can not write Cd multi line when I run parallell and chose time "transient".

It's show

""Drag Convergence"
"Flow Time" "Cd"
3.87500e-02 1.61505e+03
"

when I chose time"steady"

"Drag Convergence"
"Flow Time" "Cd"
1.00000e-02 1.09653e+02
2.00000e-02 -5.27841e+00
3.00000e-02 -4.84571e+01
4.00000e-02 -6.28311e+01
5.00000e-02 -1.34413e+02
6.00000e-02 -2.63939e+02
"

I need to write in Cd file same steady. Thank you.

[HariCharan]

Thanks very much Chandrakanth. It worked

[jingl1]

Hi, syavash, I have the same question that the 2D contour can't be shown, while I just got the grid. I am pretty sure that no boundaries in the "Surfaces"
list be selected in Contour window. Can you help me? Thank you very much.

Originally Posted by syavash

Be sure that no boundaries in the "Surfaces" list be selected in Contour window.

Bests.

[syavash]

Originally Posted by jingl1

Hi, syavash, I have the same question that the 2D contour can't be shown, while I just got the grid. I am pretty sure that no boundaries in the "Surfaces"
list be selected in Contour window. Can you help me? Thank you very much.

Hi,

Can you post a picture of what you get from Contour panel?!

[hellsblade.91]

I am also facing the same problem did any one figure it out what was wrong ?

[ywan168]

Yes, I faced the same problem. I could not see filled mesh after selected 'Face' option. And as result, I cannot see filled contours after running. Any one could give me a hint to resolve this problem? Because it did not have problem at teh beginning.

Thanks in advance.