The variable at the edge of boundary layer

somia baali · April 8, 2006, 00:22

hi,there. I am trying to compute the flow and heat transfer around a cylinder by FLUENT. I want to get the variable at the edge of boundary layer such as the temperature,velocity. But I can't find the method to report these values. Is there the option in Fluent to report this. or must I use the UDF to get these varibles? Also,I want to know if the referece values in the Report panel can be changed. I want to use the value at the edge of boundary layer as referece values, and that's not a single value, but varying with the position. I wonder if anybody has this kind of experience. And I'll appreciate any response. Thanks a lot!!

Maximus

somia baali · November 30, 2020, 15:25

i have the same your problem to determine Nu number. after this time have you any solution please

April 8, 2006, 00:22	The variable at the edge of boundary layer	#1
maximus Guest Posts: n/a	hi,there. I am trying to compute the flow and heat transfer around a cylinder by FLUENT. I want to get the variable at the edge of boundary layer such as the temperature,velocity. But I can't find the method to report these values. Is there the option in Fluent to report this. or must I use the UDF to get these varibles? Also,I want to know if the referece values in the Report panel can be changed. I want to use the value at the edge of boundary layer as referece values, and that's not a single value, but varying with the position. I wonder if anybody has this kind of experience. And I'll appreciate any response. Thanks a lot!! Maximus somia baali likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] bad trailing edge boundary layer with snappyHexMesh	draufunddran	OpenFOAM Meshing & Mesh Conversion	14	March 1, 2018 10:42
How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh	tomyangbath	FLUENT	18	October 12, 2016 07:57
[snappyHexMesh] Boundary layer in a pipe	Clementhuon	OpenFOAM Meshing & Mesh Conversion	6	March 12, 2012 13:41
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6	prashanthreddyh	ANSYS Meshing & Geometry	1	December 20, 2011 01:35
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

November 30, 2020, 15:25		#2
somia baali New Member physics baali Join Date: Nov 2020 Posts: 10 Rep Power: 6	i have the same your problem to determine Nu number. after this time have you any solution please