Problem of B.C. in Eulerian multiphase model -- CFD Online Discussion Forums

May 12, 2002, 12:52	Problem of B.C. in Eulerian multiphase model	#1
Derek Jing Guest Posts: n/a	I am simulate fine powders flowing through the nozzle of a hopper. Initially the powder fill the hopper to a position 10 mm below the top. The top of the hopper is open. I am using FLUENT 6.0 Eulerian multiphase model. I apply outflow B.C. at both the bottom (nozzle) and the top of the hopper. Now the problem is that the largest velocity of powder exist at the powder surface. I think this result is unreasonable. I guess this problem is due to the B.C. I applied at the top face. So, what kind of B.C. shohld I apply for the top face of hopper? Thank you very much. sinaupdate likes this.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF problem in multiphase model	Amir Khodabandeh	FLUENT	1	March 13, 2009 09:43
DEFINE_INIT in multiphase eulerian model	isabel	FLUENT	0	January 21, 2009 15:13
Get the lift force in Eulerian multiphase model	Summer	FLUENT	0	July 29, 2008 12:27
Converge problem for multiphase flow	Jen	FLUENT	2	September 8, 2005 09:47
Two phase Eulerian Model Problem	senthil	FLUENT	5	May 21, 2003 03:55

All times are GMT -4. The time now is 05:03.