How to do Share topology in fluent in Journal

CFD_Mike · October 15, 2023, 07:23

I'm trying to automate some workflows with journal files. My geometry consists of two domains, an outer domain and an inner domain, connected by an interface. The inner domain has a MRF and the outer domain is stationary. I've looked through the fluent text command list and there doesn't seem to be a single command that does share topology. I've tried re-creating it with.

/boundary/modify/create/ "" / internal

and

/boundary/remesh/remesh-face-zones-conformally

however the resultant interface appears to be non-conformal. I use the join intersect setting on share topology. I'm on version 2022R1.

Does anyone have any advice on how I could re-create the share topology task with journal TUI?

CFD_Mike · November 22, 2023, 17:56

Found the solution, turns out I missed the "objects/join-intersect" command in the text command list

October 15, 2023, 07:23	How to do Share topology in fluent in Journal	#1
CFD_Mike New Member Join Date: Oct 2023 Posts: 4 Rep Power: 3	I'm trying to automate some workflows with journal files. My geometry consists of two domains, an outer domain and an inner domain, connected by an interface. The inner domain has a MRF and the outer domain is stationary. I've looked through the fluent text command list and there doesn't seem to be a single command that does share topology. I've tried re-creating it with. /boundary/modify/create/ "" / internal and /boundary/remesh/remesh-face-zones-conformally however the resultant interface appears to be non-conformal. I use the join intersect setting on share topology. I'm on version 2022R1. Does anyone have any advice on how I could re-create the share topology task with journal TUI?

November 22, 2023, 17:56		#2
CFD_Mike New Member Join Date: Oct 2023 Posts: 4 Rep Power: 3	Found the solution, turns out I missed the "objects/join-intersect" command in the text command list MAHESH9966 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Call fluent in meshing mode and run a journal	Captain Convergence	FLUENT	2	April 5, 2024 09:10
how to run fluent from matlab without using aas toolbox?	artemis96	ANSYS	7	May 23, 2022 13:16
How to use loop statements in FLUENT journal?	didiean	FLUENT	2	December 13, 2017 02:57
How to run a series of Fluent journal files in order?	jyoung79	FLUENT	2	September 22, 2014 09:52
Fluent jobs through pbs	ibnkureshi	FLUENT	5	June 9, 2011 14:43