Using TUI to Change BC's

bigalou28 · January 14, 2020, 21:01

I would like to use a journal file to read in a .cas file, change the cell-zone condition of the fluid (specifically, the rotational velocity), and then change multiple boundary conditions. All of the boundaries are set as velocity inlets, but I'd like to change the y-velocity in all of them to the same value.

For the BC's, I know you start it by typing:

/define boundary-conditions velocity-inlet inletname

But I am unsure how to change the specific parameters.

AlexanderZ · January 14, 2020, 22:40

type /define boundary-conditions
press enter
fluent will show your all available options

bigalou28 · January 14, 2020, 23:01

Quote:

Originally Posted by AlexanderZ

type /define boundary-conditions
press enter
fluent will show your all available options

Thanks for the help. I have what I need running. This will likely save a lot of time.

January 14, 2020, 21:01	Using TUI to Change BC's	#1
bigalou28 New Member Alex Join Date: Jan 2020 Posts: 2 Rep Power: 0	I would like to use a journal file to read in a .cas file, change the cell-zone condition of the fluid (specifically, the rotational velocity), and then change multiple boundary conditions. All of the boundaries are set as velocity inlets, but I'd like to change the y-velocity in all of them to the same value. For the BC's, I know you start it by typing: /define boundary-conditions velocity-inlet inletname But I am unsure how to change the specific parameters. Svetlana likes this.

January 14, 2020, 22:40		#2
AlexanderZ Senior Member Alexander Join Date: Apr 2013 Posts: 2,363 Rep Power: 34	type /define boundary-conditions press enter fluent will show your all available options Svetlana and bigalou28 like this. __________________ best regards ****************************** press LIKE if this message was helpful

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set BCs programmatically	incompressible	OpenFOAM Programming & Development	6	November 20, 2017 03:47
Not defined orientation change while running SU2_CFD	mdawson25	SU2	4	May 11, 2017 10:52
How to use "translation" in solidBodyMotionFunction in OpenFOAM	rupesh_w	OpenFOAM Running, Solving & CFD	5	August 16, 2016 05:27
Stage Frame Change + Porous Domain	CFX_Beginner	CFX	10	August 10, 2015 05:28
[swak4Foam] switch between existing BCs with groovyBC?!	michielm	OpenFOAM Community Contributions	3	September 4, 2013 09:01