Using radiation model for simulation of flat plate solar collector

marjanbn · October 13, 2014, 23:34

Hello everyone,
My research is about simulating flat plate solar collector with Ansys Fluent but I have some problems using radiation model.I will be so thankful if anyone could answer my questions. My model includes glass cover, absorber plate (copper), air gap (between absorber plate and glass) and tube (water).
First, I tried using Do (Discrete Ordinates) for radiation model but do-intensity did not converge (Do-intensity). Then, I tried using P1 model. This model works but only without gravity. Then, I tried using DTRM but it does not work since my model includes sliding meshes. Finally, I used only solar load (with solar calculator) without activating any radiation model. This option works only without gravity too. Actually, I am new in using radiation model in Ansys. I don't know which model is suitable for my case.
I want to know that how I can activate gravity option since my simulations with gravity and radiation model does not work at all. I need to activate gravity due to free convection in air passage between the absorber plate and glass cover.

marjanbn · October 15, 2014, 05:44

So anybody here can give me a hand with this problem?

ravipvb · March 15, 2015, 11:27

Helo,
could you solve your problem?
Ravi

October 13, 2014, 23:34	Using radiation model for simulation of flat plate solar collector	#1
marjanbn New Member Marjan Join Date: Sep 2014 Posts: 3 Rep Power: 12	Hello everyone, My research is about simulating flat plate solar collector with Ansys Fluent but I have some problems using radiation model.I will be so thankful if anyone could answer my questions. My model includes glass cover, absorber plate (copper), air gap (between absorber plate and glass) and tube (water). First, I tried using Do (Discrete Ordinates) for radiation model but do-intensity did not converge (Do-intensity). Then, I tried using P1 model. This model works but only without gravity. Then, I tried using DTRM but it does not work since my model includes sliding meshes. Finally, I used only solar load (with solar calculator) without activating any radiation model. This option works only without gravity too. Actually, I am new in using radiation model in Ansys. I don't know which model is suitable for my case. I want to know that how I can activate gravity option since my simulations with gravity and radiation model does not work at all. I need to activate gravity due to free convection in air passage between the absorber plate and glass cover. unta0 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 06:36
Radiation Modeling	Chris89	CFX	20	August 14, 2014 08:51
solar radiation with chtMultiRegionSimpleFoam	kocs	OpenFOAM Pre-Processing	0	July 16, 2014 03:21
GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source	silvan	CFX	3	June 16, 2014 10:49
Regarding Solar Radiation model	kiran kumar	FLUENT	0	December 29, 2006 10:57

October 15, 2014, 05:44		#2
marjanbn New Member Marjan Join Date: Sep 2014 Posts: 3 Rep Power: 12	So anybody here can give me a hand with this problem?

March 15, 2015, 11:27		#3
ravipvb New Member Ravi Sharma Join Date: Aug 2012 Posts: 6 Rep Power: 14	Helo, could you solve your problem? Ravi