|
[Sponsors] |
Unassigned interface zones found. Flow is not initialized |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
YANNAPOL SRIPHUTKIAT
Join Date: Sep 2014
Posts: 43
Rep Power: 11 ![]() |
Dear all,
I have tried by following this http://blog.sina.com.cn/s/blog_54093b2a01014j8e.html but my problem is at the last step "Run Calculation" ************************************************** ***** WARNING: Unassigned interface zone detected for interface 6 Unassigned interface zones found. Flow is not initialized. Error: GENERAL-CAR-CDR: invalid argument [1]: improper list Error Object: 0 ************************************************** ***** I already attach screen shot of my Fluent in the attachments Please help me !!!! |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Jamal Foroozesh
Join Date: Oct 2012
Location: Iran
Posts: 162
Rep Power: 13 ![]() |
Hi
Please go to define<mesh interface |
|
![]() |
![]() |
![]() |
![]() |
#3 |
Member
YANNAPOL SRIPHUTKIAT
Join Date: Sep 2014
Posts: 43
Rep Power: 11 ![]() |
Thank you for your suggestion,
My mesh interface has similar region "contact_region-src" in both Interface Zone1 and Interface Zone 2 according to http://www.arc.vt.edu/ansys_help/flu...orm_using.html they have rotor and stater interface, but mine has only contact_region-scr. Thus, I can not create mesh interface. What should I do ?? Last edited by YANNAPOL; October 8, 2014 at 02:30. |
|
![]() |
![]() |
![]() |
![]() |
#4 | |
Senior Member
Jamal Foroozesh
Join Date: Oct 2012
Location: Iran
Posts: 162
Rep Power: 13 ![]() |
Quote:
please write details about your problem. |
||
![]() |
![]() |
![]() |
Tags |
fluent 14.5, interface elements, nozzle flow, run calculation, water and air |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow rate not conserved in turbomachine, interface defined wrong? | wildli | FLUENT | 3 | September 15, 2022 12:19 |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
8x icoFoam speed up with Cufflink CUDA solver library | kmooney | OpenFOAM Running, Solving & CFD | 42 | November 6, 2012 11:37 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |