Parcels/particles injection

MMatt · January 14, 2020, 12:12

Hello,

I have an issue regarding parcels/particles in Fluent. I want to use a surface as a starting point to send particles to my fluid domain. I have set that properly (I think) in the injection dialog box, meaning I have set the correct surface, the particle diameter, and the flow rate.

However, no matter which time step I use, fluent always injects the same number of particles into the domain. How can I control that number?

I have a defined number of particles per second that I want to introduce to the domain.

Thanks in advance!

vinerm · January 28, 2020, 10:02

Hi

The number of particles injected depend up on the number of mesh faces on the injection surface. If you wish to inject specified number, then do not use surface injection. Use single, or group, or FILE, or UDF. Another alternative is to ensure that the surface has required number of faces.

Jordan_kal · November 12, 2021, 07:51

For the "file " injection I created a file using ((x y z u v w diameter temperature mass-flow) name)

However how would this help in getting a specified number of particles to be tracked. I have a surface that has 900 cells and I need to check for 20000,30000,60000 number of particles from this surface

January 14, 2020, 12:12	Parcels/particles injection	#1
MMatt Member MMatt Join Date: May 2013 Posts: 59 Rep Power: 13	Hello, I have an issue regarding parcels/particles in Fluent. I want to use a surface as a starting point to send particles to my fluid domain. I have set that properly (I think) in the injection dialog box, meaning I have set the correct surface, the particle diameter, and the flow rate. However, no matter which time step I use, fluent always injects the same number of particles into the domain. How can I control that number? I have a defined number of particles per second that I want to introduce to the domain. Thanks in advance!

January 28, 2020, 10:02	Faces on the Surface	#2
vinerm Senior Member Vinerm Join Date: Jun 2009 Location: Nederland Posts: 2,946 Blog Entries: 1 Rep Power: 36	Hi The number of particles injected depend up on the number of mesh faces on the injection surface. If you wish to inject specified number, then do not use surface injection. Use single, or group, or FILE, or UDF. Another alternative is to ensure that the surface has required number of faces. MMatt and Ety like this. __________________ Regards, Vinerm PM to be used if and only if you do not want something to be shared publicly. PM is considered to be of the least priority.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Injection injection-0: LOST 2 out of 20 injection locations	attaullah	FLUENT	17	March 2, 2023 11:31
UDF for particle injection using file	shahjehan	Fluent UDF and Scheme Programming	2	June 28, 2020 11:44
file injection.: continuity fail; volume injection.: wrong total mass	blerli_91	Fluent Multiphase	6	October 2, 2018 06:34
injection problem	Mark New	FLUENT	0	August 4, 2013 02:30
jou file command for the injection!	asal	FLUENT	0	June 4, 2013 05:15

November 12, 2021, 07:51		#3
Jordan_kal New Member Jordan Join Date: Jun 2021 Posts: 12 Rep Power: 5	For the "file " injection I created a file using ((x y z u v w diameter temperature mass-flow) name) However how would this help in getting a specified number of particles to be tracked. I have a surface that has 900 cells and I need to check for 20000,30000,60000 number of particles from this surface