 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2019, 15:10
|
Floating Point Exception Error
|
#1 |
|
New Member
ahmad
Join Date: Nov 2019
Posts: 2
Rep Power: 0  |
I am simulating nozzle inside tank. After meshing the domain in ANSYS Mechanical Workbench and Importing in Fluent, I am constantly getting the following message "floating point exception" in calculation.
Please can somebody solve my problem? I am attaching some mesh images below: Mesh Statistics: No of elements : 473600 Element Size : 10 mm Minimum Element Skewness: 1.3057e-010 Maximum Element Skewness: 0.50 Minimum Element Quality: 1.3695e-002 Maximum Element Quality: 0.83662 Minimum Aspect Ratio: 1.847 Maximum Aspect Ratio: 19.32 Maximum Orthogonal Qualify: 0.73972 Maximum Orthogonal Qualify: 1 Anyone Please Help.. |
|
|
|
|
|
November 5, 2019, 12:17
|
|
#2 |
|
Senior Member
Lolita
Join Date: Aug 2016
Posts: 118
Rep Power: 10 |
Mostly these kinds of errors occur if you have given any unphysical condition in your problem. or if there is problem in boundary conditions.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 08:11 |
| [General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 15:06 |
| Floating point error and divergence detected | aannjj | FLUENT | 0 | July 2, 2013 04:44 |
| [swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..." | sega | OpenFOAM Community Contributions | 12 | February 17, 2010 10:30 |
| [Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
1Likes
Linear Mode
