Could not delete output file: temp2.tmp

civilengineer · February 12, 2014, 06:17

Hi, thank you for your help in advance.

Whenever I want to run a simulation after doing up the model setup etc, this message pops up immediately after clicking "run simulation".

"Could not delete output file: temp2.tmp"
231.jpg

Any explanation why this occurs and the steps to remedy it will be greatly appreciated.

Regards

FlowScience · February 18, 2014, 11:26

Seems to be that you have started a second simulation in the same directory as the first one

.
The used temporary files are the same in this case and gives the error message.

February 12, 2014, 06:17	Could not delete output file: temp2.tmp	#1
civilengineer New Member Leon Join Date: Dec 2013 Posts: 2 Rep Power: 0	Hi, thank you for your help in advance. Whenever I want to run a simulation after doing up the model setup etc, this message pops up immediately after clicking "run simulation". "Could not delete output file: temp2.tmp" 231.jpg Any explanation why this occurs and the steps to remedy it will be greatly appreciated. Regards

February 18, 2014, 11:26		#2
FlowScience New Member Flow Science Deutschland Join Date: Jul 2012 Posts: 1 Rep Power: 0	Seems to be that you have started a second simulation in the same directory as the first one . The used temporary files are the same in this case and gives the error message. spaudel likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 09:46
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[swak4Foam] Error bulding swak4Foam	sfigato	OpenFOAM Community Contributions	18	August 22, 2013 13:41
[swak4Foam] funkySetFields compilation error	tayo	OpenFOAM Community Contributions	39	December 3, 2012 06:18
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 02:24