Solver crashed

mochammad ramzi · July 24, 2018, 10:44

Hi all

I'm a naval architecture student and new comer of Fine/Marine software. I'm currently perform simulation of 3D drop object of ship. However, I found problem that I need to ask. Since yesterday when I run it, it has massage on Fine task manager "No new results are available." and the solver is crashed.
what should I check when I had that problem.?

Thank you

Stethedoctor · August 19, 2019, 15:44

hello,

I'm trying to do the tutorial exercises. however, I launch the calculation, the solver crashed.
the exercise is the first of the tutorials found on the net, driven_cavity.

can you tell what is my simply problem?

thanks

Stethedoctor · March 19, 2020, 04:07

Hello, i have run a solver, in parallel and also in serial mode, but i obtain the same results.
Solver crashed :confuso: after 5078 cycle, can you tell me what is the problem?
i have launch a simple simulation, bare hull, resistance at 10kn, mesh report ok.

thank you in advance

July 24, 2018, 10:44	Solver crashed	#1
mochammad ramzi New Member mochammad ramzi Join Date: Jul 2018 Posts: 2 Rep Power: 0	Hi all I'm a naval architecture student and new comer of Fine/Marine software. I'm currently perform simulation of 3D drop object of ship. However, I found problem that I need to ask. Since yesterday when I run it, it has massage on Fine task manager "No new results are available." and the solver is crashed. what should I check when I had that problem.? Thank you bayu likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
fluent divergence for no reason	sufjanst	FLUENT	2	March 23, 2016 17:08
thobois class engineTopoChangerMesh error	Peter_600	OpenFOAM	4	August 2, 2014 10:52
Divergence problem	Smaras	FLUENT	13	February 21, 2013 06:03
3d vof	Smaras	FLUENT	2	February 19, 2013 07:58
why the solver reject it? Anyone with experience?	bearcat	CFX	6	April 28, 2008 15:08

August 19, 2019, 15:44		#2
Stethedoctor New Member Stefano Join Date: Aug 2019 Posts: 5 Rep Power: 7	hello, I'm trying to do the tutorial exercises. however, I launch the calculation, the solver crashed. the exercise is the first of the tutorials found on the net, driven_cavity. can you tell what is my simply problem? thanks

March 19, 2020, 04:07		#3
Stethedoctor New Member Stefano Join Date: Aug 2019 Posts: 5 Rep Power: 7	Hello, i have run a solver, in parallel and also in serial mode, but i obtain the same results. Solver crashed :confuso: after 5078 cycle, can you tell me what is the problem? i have launch a simple simulation, bare hull, resistance at 10kn, mesh report ok. thank you in advance