|
[Sponsors] |
How to export pressure data at one degree crank angle resolution |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Avilash Jain
Join Date: Sep 2017
Posts: 7
Rep Power: 8 ![]() |
Hello,
Can I export pressure data from Converge at one-degree crank angle resolution instead of a finer resolution? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Tobias
Join Date: May 2016
Location: Germany
Posts: 283
Rep Power: 11 ![]() |
Would be great if thats possible, but there is no way to do this at the moment, as far as i know.
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
Nitesh Attal
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 113
Rep Power: 9 ![]() |
Hello Avilash,
The frequency at which *.out files (Integrated quantities e.g. thermo*.out that contains pressure data) are written out can be controlled by the parameter twrite_files in inputs.in. If you would instead like to control the frequency of post* files (3D data files) please use the parameter twrite_post in inputis.in. Thanks, |
|
![]() |
![]() |
![]() |
Tags |
converge cfd |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 30 | November 6, 2023 21:00 |
[OpenFOAM] How to get the coordinates of velocity data at all cells and at all times | vidyadhar | ParaView | 9 | May 20, 2020 20:06 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
export data at nodes | Meenu | FLUENT | 1 | December 30, 2011 01:24 |