|
[Sponsors] |
December 19, 2007, 12:47 |
2D Simulation ANSYS CFX
|
#1 |
Guest
Posts: n/a
|
is it possible to perform a 2D simulation in ANSYS CFX 11.0? I'm trying to export a 2D mesh from ICEM CFD, but the program answers that is not possible to write a .gtm file because of absence of volume elements.
|
|
December 19, 2007, 14:28 |
Re: 2D Simulation ANSYS CFX
|
#2 |
Guest
Posts: n/a
|
This question is being asked a lot these days...
See FAQ: http://www.cfd-online.com/Wiki/Ansys..._simulation.3F |
|
December 20, 2007, 04:12 |
Re: 2D Simulation ANSYS CFX
|
#3 |
Guest
Posts: n/a
|
Thank you jakjak.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compressible Flow in Ansys CFX | bcheruk | CFX | 15 | July 6, 2017 07:30 |
simulation of a radial hydrodynamic bearing in ANSYS CFX | Jalen | ANSYS | 1 | October 4, 2013 11:40 |
URANS in ANSYS CFX | brissyben | CFX | 3 | October 6, 2009 18:35 |
Problems on H2/air CFX simulation | xulixian | OpenFOAM Running, Solving & CFD | 2 | April 14, 2009 16:00 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 02:10 |