What would be the difference between a solid and frozen if only single body exists in

RabiArya · July 20, 2021, 04:26

I have a single cylinder for internal flow, thus what would be the difference if I make it as a solid body or frozen body?

ghorrocks · July 20, 2021, 07:45

I have no ide what you are asking. Please show an image of what you are asking and how you are proposing to model it.

RabiArya · July 20, 2021, 07:51

I am not being allowed to share the media, it says "the forum has disabled media sharing".
Anyway I have a cylinder for internal flow. There is a inlet and outlet on two opposite cross section of cylinder. What would be the difference if I model the cylinder as " Add material" Or if as "Add frozen"?

evcelica · July 20, 2021, 13:58

No Difference.
Add frozen is just there for modeling purposes when you want to make a separate body, and not combine the bodies.
It makes no difference for analysis purposes.

July 20, 2021, 04:26	What would be the difference between a solid and frozen if only single body exists in	#1
RabiArya Member Rabi Pathak Join Date: Jul 2020 Posts: 32 Rep Power: 6	I have a single cylinder for internal flow, thus what would be the difference if I make it as a solid body or frozen body?

July 20, 2021, 07:45		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	I have no ide what you are asking. Please show an image of what you are asking and how you are proposing to model it. RabiArya likes this. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

July 20, 2021, 13:58		#4
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,188 Rep Power: 23	No Difference. Add frozen is just there for modeling purposes when you want to make a separate body, and not combine the bodies. It makes no difference for analysis purposes. RabiArya likes this.

July 20, 2021, 07:51		#3
RabiArya Member Rabi Pathak Join Date: Jul 2020 Posts: 32 Rep Power: 6	I am not being allowed to share the media, it says "the forum has disabled media sharing". Anyway I have a cylinder for internal flow. There is a inlet and outlet on two opposite cross section of cylinder. What would be the difference if I model the cylinder as " Add material" Or if as "Add frozen"?