|
[Sponsors] |
December 22, 2006, 09:36 |
Info Radiation Monte Carlo Model
|
#1 |
Guest
Posts: n/a
|
Hello, I'm a student of engeneering and I have a problem with Monte Carlo, and I have two domain one is Fluids and the second one is Solids. I have imposed the Boundary Condition of radiation radiation Model (Monte Carlo) but in the solver manager I don't see the residual of Irradiation and the energy equation don't go to convergence, instead of other equation like Momentum and Mass, and turbolent equation. I don't understand because the Solver Manager don't plot the residual of Irradiation even if the boundary conditions Interface has been imposed to opaque with emissivity 0,9 and diffuse 0,2.
Please help me! |
|
December 22, 2006, 10:01 |
Re: Info Radiation Monte Carlo Model
|
#2 |
Guest
Posts: n/a
|
Dear Matteo,
The Monte Carlo model does not solve any equation; therefore, there is no concept of residual as for the other equations you mentioned. Instead, there is statistical information in the output file: %SD for standard deviation in the volume and at the surfaces. The lower this value is the better your MC solution is. However, once the solution has reasonably converged it will not go down as residuals do. It will remain at "error level" the solution contains. To reduce it, you must increase the Number of Histories (kind of mesh refining) .. Good luck, and happy holidays Opaque |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How model radiation of both solid wall and fluid£¿ | Harry Qiu | FLUENT | 2 | February 4, 2013 00:04 |
heat transfer with s2s radiation model in fluent | D. L. | FLUENT | 3 | July 31, 2008 08:40 |
Meshing for Monte Carlo Radiation | Zoran | CFX | 6 | November 30, 2007 11:03 |
radiation model | brian | FLUENT | 0 | July 27, 2007 11:57 |
definition difficulty-->DO radiation model | Harry Qiu | FLUENT | 0 | March 29, 2001 10:19 |