|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
Join Date: Aug 2012
Posts: 269
Rep Power: 15 ![]() |
Is there a way of counting the number of nodes in the boundary layer in CFD-Post?
The first photo shows the velocity contour at 90% span and the mesh around the blade. Does it have the minimum requirement of 10 nodes in the boundary layer? The second photo shows the distribution of y+ around the blade. I specifed Y+=1 in turbogrid but the the distribution shows that the maximum local y plus is 5. Do I have to refine the mesh near the boundary? Is it correct way of inspecting Y+? I am using SST turbulence model. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
[snappyHexMesh] Error defining boundary layer around cube snappyHexMesh | crizpi21 | OpenFOAM Meshing & Mesh Conversion | 5 | October 16, 2021 10:56 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |