 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2017, 10:03
|
unusual geometry size in CFX pre
|
#1 |
|
Senior Member
raunak jung pandey
Join Date: Jun 2016
Posts: 102
Rep Power: 10  |
My geometry was created in mm with total length 100 mm. The mesh was made in ICEM in cm units. But when the mesh is imported to CFX pre. It is shown in m. Also, the dimension has increased and shows total length of a domain as 10 m.
Also, all the calculations have been done with the length as 10 m. It's very unusual. How to solve this problem? |
|
|
|
|
|
June 9, 2017, 11:19
|
|
#2 |
|
Member
Peter
Join Date: Sep 2011
Location: Germany
Posts: 39
Rep Power: 15 |
In CFX Pre
a) scale the mesh back to the intended size and work with [m] or b) change the units (Edit-Options) to [mm] |
|
|
|
|
|
 |
| Tags |
| cfx pre, geometry ansys, scaling |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Only two turbulence options available in CFX Pre | Jack001 | CFX | 5 | March 30, 2016 03:47 |
| Defining a domain in CFX Pre | ashtonJ | CFX | 1 | June 13, 2011 03:34 |
| [Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 16:45 |
| Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 15:37 |
| Geometry and meshing with CFX | Bob Crad | CFX | 3 | January 7, 2004 13:56 |
2Likes
Linear Mode
