 |
 |
 |
|
|
|
[Sponsors] | ||||
August 8, 2015, 10:01
|
Error in low timestep. why?
|
#1 |
|
Member
M S
Join Date: Feb 2015
Posts: 30
Rep Power: 11  |
Hello.
my model in cfx is ok in tmesteps over 0.025 second but it doesn't run in timestep lower than 0.025 and get an error. Do you know why? |
|
|
|
|
|
August 8, 2015, 22:37
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,870
Rep Power: 144 |
Most likely this is due to numerical round off problems. If you run double precision you should be able to fix this.
Also improved mesh quality and initial conditions can assist. |
|
|
|
|
|
 |
| Tags |
| cfx, timestep |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low Reynolds Number SST Model | Josh | CFX | 41 | June 4, 2023 20:00 |
| Wrong interface curvature capturing and contact line calculation at low capillary nu | Mahmoud_aboukhedr | OpenFOAM Running, Solving & CFD | 0 | April 14, 2015 15:04 |
| Stopping OpenFOAM on low timestep? | galengisler | OpenFOAM Running, Solving & CFD | 0 | August 2, 2014 11:59 |
| Modifying sonicFoam to run with variable timestep - strange results | dalaron | OpenFOAM Programming & Development | 1 | September 2, 2013 08:21 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
1Likes
Linear Mode
