 |
 |
 |
|
|
|
[Sponsors] | ||||
October 29, 2014, 11:28
|
y plust value in CFX
|
#1 |
|
New Member
Sharon Wilcox
Join Date: Aug 2014
Location: California, USA
Posts: 21
Rep Power: 12  |
during the post processing, under variables, i saw that my solver yplus value is [ min 0 max 66789] and yplus (min 0 max 38079). Do these values mean that my yplus values are too high? I need at least below 100 yplus value.
|
|
|
|
|
|
October 29, 2014, 18:28
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,872
Rep Power: 144 |
You cannot assess accuracy on y+ alone. You need to do a mesh sensitivity check.
But y+=38000 is pretty huge and is definitely far too big. You will definitely need a finer mesh than that. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX Treatment of Laminar and Turbulent Flows | Jade M | CFX | 18 | September 15, 2022 08:08 |
| High Resolution (CFX) vs 2nd Order Upwind (Fluent) | gravis | ANSYS | 3 | March 24, 2011 03:43 |
| CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 14:22 |
| PhD using CFX | Rui | CFX | 9 | May 28, 2007 06:59 |
| FSI using CFX and ANSYS | Bi Chang | CFX | 2 | May 10, 2005 05:47 |
1Likes
Linear Mode
