Hill criteria

khadija · May 24, 2013, 13:08

Hi,
please, how to introduce Hill' parameters in ansys

thanks in advance

ghorrocks · May 24, 2013, 20:23

Do you want to introduce a mountain, hill or just a termite mound?

Other than that, refer to this: http://www.cfd-online.com/Wiki/Ansys...ible_answer.3F

khadija · May 25, 2013, 06:53

Quote:

Originally Posted by ghorrocks

Do you want to introduce a mountain, hill or just a termite mound?

Other than that, refer to this: http://www.cfd-online.com/Wiki/Ansys...ible_answer.3F

hi,

no, I want to know how to introduce the plasticity criterion Hill and parameters

May 24, 2013, 13:08	Hill criteria	#1
khadija New Member khadija Join Date: May 2013 Posts: 2 Rep Power: 0	Hi, please, how to introduce Hill' parameters in ansys thanks in advance

May 24, 2013, 20:23		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	Do you want to introduce a mountain, hill or just a termite mound? Other than that, refer to this: http://www.cfd-online.com/Wiki/Ansys...ible_answer.3F mvoss likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What value shall I set for the Convergence criteria?	steventay	CFX	7	May 14, 2010 13:44
Convergence Criteria	edwin	FLUENT	1	February 14, 2008 20:24
How can I set the converge criteria properly?	Alina	FLUENT	3	September 7, 2007 17:55
Convergence criteria	Gaurav	Siemens	0	February 3, 2006 05:53
CAVITATION (convergence criteria & discretization)	ROOZBEH	FLUENT	1	October 6, 2003 10:32