Inflation/Prism layer for rough surface -- CFD Online Discussion Forums

February 23, 2017, 01:00	Inflation/Prism layer for rough surface	#1
Dhairya@CFD New Member Dhairyasheel deshmukh Join Date: Jan 2017 Posts: 4 Rep Power: 9	Hello, I am studying the effect of surface roughness on a performance of centrifugal pump using Ansys. I have used inflation layer in meshing to capture boundary layer near the blade. the height of inflation layer is approx. 1mm. I want to know that can I go with the same inflation layer for all simulations with different values of roughness or I have to change it? If so how to relate the height of inflation layer to the mean grain size(0-1.25mm for my case) of wall roughness. thank You, Regards, GSR likes this.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Seperated two surface inflation mesh ( boundary layer)	Onurozcan	ANSYS Meshing & Geometry	2	December 10, 2015 09:01
Seperated tow surface inflation mesh ( boundary layer)	Onurozcan	Main CFD Forum	4	November 29, 2015 06:32
[snappyHexMesh] crash sHM	H25E	OpenFOAM Meshing & Mesh Conversion	11	November 10, 2014 12:27
[snappyHexMesh] Problem with Sanpper, surface still Rough	Zephiro88	OpenFOAM Meshing & Mesh Conversion	7	November 5, 2014 13:05
[snappyHexMesh] Snap Precision to a STL Surface	malaboss	OpenFOAM Meshing & Mesh Conversion	16	July 26, 2013 02:44

All times are GMT -4. The time now is 19:07.