[DesignModeler] Creating two connected volumes with one contact face

Ashpour · August 23, 2022, 14:39

Hey guys, in Gambit its easy two split a volume with a face to create two smaller volumes and one face between them, but in ANSYS (Space Claim or other geometry programs) when i split a volume with a face, it generates two volumes with two surfaces between them but I want only one contact face, any suggestions?

siw · August 25, 2022, 03:22

Use Shared Topology.

Ashpour · August 25, 2022, 08:38

Quote:

Originally Posted by siw

Use Shared Topology.

in creating geometry stage or in mesh generating stage?

siw · September 5, 2022, 07:17

Do this as the final part of the geometry preparation. The shared topology geometry is then passed to the mesh generation application.

August 23, 2022, 14:39	Creating two connected volumes with one contact face	#1
Ashpour New Member Abbas Shpour Join Date: Jun 2022 Posts: 3 Rep Power: 4	Hey guys, in Gambit its easy two split a volume with a face to create two smaller volumes and one face between them, but in ANSYS (Space Claim or other geometry programs) when i split a volume with a face, it generates two volumes with two surfaces between them but I want only one contact face, any suggestions?

August 25, 2022, 03:22		#2
siw Senior Member Stuart Join Date: Jul 2009 Location: Portsmouth, England Posts: 742 Rep Power: 26	Use Shared Topology. Ashpour likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[snappyHexMesh] Motorbike example: Failed 1 mesh checks	lhsihan	OpenFOAM Meshing & Mesh Conversion	2	December 11, 2018 08:54
[simpleFoam] Floating point exception	seuchsy	OpenFOAM Running, Solving & CFD	3	November 3, 2016 10:29
Hydrostatic Pressure and Gravity	miliante	OpenFOAM Running, Solving & CFD	132	October 7, 2012 23:50
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 06:50

September 5, 2022, 07:17		#4
siw Senior Member Stuart Join Date: Jul 2009 Location: Portsmouth, England Posts: 742 Rep Power: 26	Do this as the final part of the geometry preparation. The shared topology geometry is then passed to the mesh generation application.