[ICEM] Periodic surfaces matching mesh

KLA · October 4, 2021, 06:25

hello everyone,

I am a beginer in ICEM.

When generating periodic surfaces mesh on Ansys Meshing you have the option to create matching surface meshing which is needed for periodic rotation.

Is there a similar option on ICEM ? if not, how do you ensure that the mesh on the intended periodic surfaces is the same ?

Thank you

Gert-Jan · November 2, 2021, 11:49

This is possible in the menu Mesh>Global Mesh Setup>Set up Periodicity

KLA · November 3, 2021, 05:57

Quote:

Originally Posted by Gert-Jan

This is possible in the menu Mesh>Global Mesh Setup>Set up Periodicity

Thank you for your reply. I will try it with my case.

October 4, 2021, 06:25	Periodic surfaces matching mesh	#1
KLA New Member Join Date: Feb 2020 Posts: 10 Rep Power: 6	hello everyone, I am a beginer in ICEM. When generating periodic surfaces mesh on Ansys Meshing you have the option to create matching surface meshing which is needed for periodic rotation. Is there a similar option on ICEM ? if not, how do you ensure that the mesh on the intended periodic surfaces is the same ? Thank you

November 2, 2021, 11:49		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,928 Rep Power: 28	This is possible in the menu Mesh>Global Mesh Setup>Set up Periodicity KLA likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] non uniform mesh near the stl object	vava10	OpenFOAM Meshing & Mesh Conversion	0	January 31, 2021 15:41
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
periodic straight tube flow, no mesh independent solution for pressure gradient	thijs1909	FLUENT	5	May 16, 2018 10:04
Mesh Independance Test VS Matching CFD Results with Experiments	fadoobaba	FloEFD, FloWorks & FloTHERM	5	May 10, 2018 09:49
How to make periodic two faces of identical surface and different mesh	dmaz	ANSYS	1	September 7, 2015 17:08