[ANSYS Meshing] Meshing Sharp angles

MarwanEssam · January 7, 2018, 12:51

There are sharp edges in my geometry that I am not sure how to mesh.

The simulation is for air flow inside a triangular cross section.
My question is what mesh method to use to deal with the sharp edges and capture the boundary layer?

Christophe · January 7, 2018, 20:20

You can try applying a very small radius to the knife edge, and change advanced inflation options to compression, and turn the sizing features of proximity and curvature on.

MarwanEssam · January 10, 2018, 14:01

Quote:

Originally Posted by Christophe

You can try applying a very small radius to the knife edge, and change advanced inflation options to compression, and turn the sizing features of proximity and curvature on.

Thanks for the help it worked.

January 7, 2018, 20:20		#2
Christophe Member Join Date: Jan 2015 Posts: 62 Rep Power: 11	You can try applying a very small radius to the knife edge, and change advanced inflation options to compression, and turn the sizing features of proximity and curvature on. MarwanEssam likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Meshing strategy for 3D sharp point	D-willism	ANSYS Meshing & Geometry	23	May 14, 2020 16:55
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 11:49
[ICEM] smooth boundary layer near sharp angles	sk8190	ANSYS Meshing & Geometry	0	October 15, 2014 05:24
Meshing gaps and sharp edges by CFX	Soolmaz	Main CFD Forum	0	April 4, 2013 05:12
Meshing sharp corners - mesh for a MVG	fportela	Mesh Generation & Pre-Processing	0	March 17, 2013 12:33