[ICEM] Cannot move control points

Nat Sam · July 6, 2016, 05:35

Hi everyone !

Relatively new to ICEM... I have 2 control points on 2 edges. I'd like to move them with "Move Vertices" but the vertices don't move... What could be the issue ? On the attached pic, there's a slice of my blocking with the control points I'd like to move.

Thanks

Nat

Far · July 6, 2016, 08:31

You cannot move vertices which are associated to points. Moreover some times vertices may not move out of plane. Use some other tools in same panel or delete association of vertices and move them.

Nat Sam · July 6, 2016, 10:48

Hi Far

I dissaociated everything and tried, staying on the plane (in this case YZ plane) but they still don't move. I tried with "Set Location" but still have the same issue...
Any ideas ?

Nat Sam · July 11, 2016, 06:35

If anyone has the same problem as me, you need to activate de surfaces to which those control points belong to and then you can move them ^^

I probably didn't explain my problem well.

Have a nice week everyone ! And a nice long weekend for those who live in France

Nat

July 6, 2016, 10:48		#3
Nat Sam New Member Paurnamie Samarakone Join Date: Jun 2015 Posts: 25 Rep Power: 11	Hi Far I dissaociated everything and tried, staying on the plane (in this case YZ plane) but they still don't move. I tried with "Set Location" but still have the same issue... Any ideas ? Last edited by Nat Sam; July 7, 2016 at 08:51.

July 11, 2016, 06:35		#4
Nat Sam New Member Paurnamie Samarakone Join Date: Jun 2015 Posts: 25 Rep Power: 11	If anyone has the same problem as me, you need to activate de surfaces to which those control points belong to and then you can move them ^^ I probably didn't explain my problem well. Have a nice week everyone ! And a nice long weekend for those who live in France Nat Far and afnch like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] Calculate cross product of mesh points and given vector	DE25VT	OpenFOAM Meshing & Mesh Conversion	5	January 13, 2016 11:05
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 19:57
CFX FSI Fatal Error	unbanana	CFX	0	October 3, 2015 06:57
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[mesh manipulation] DynamicMesh - Move internal points	nucat	OpenFOAM Meshing & Mesh Conversion	2	September 6, 2014 09:54

July 6, 2016, 08:31		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	You cannot move vertices which are associated to points. Moreover some times vertices may not move out of plane. Use some other tools in same panel or delete association of vertices and move them.