[ANSYS Meshing] Asking ways to improve mesh quality.

catalysthw · May 27, 2015, 21:33

Dear. ICEMers

Please see if the low mesh quality is from O-grid and the number of nodes.

Could you suggest the way to improve mesh quality on balance?

You can check the mesh quality by entering the link as below.

http://blog.naver.com/4138761/220372464061

Thank you.

FJSJ · May 28, 2015, 11:02

Hi Hyowon,

I can not see the pictures very well to be honest. However, try to evaluate 3x3x3 determinant instead of 2x2x2 for 3D models and, at the same time, having a look at the bottom face I think you have not a good o-block association. Can you share your project file?

May 27, 2015, 21:33	Asking ways to improve mesh quality.	#1
catalysthw New Member Hyowon Lee Join Date: Feb 2013 Location: Ulsan, South Korea Posts: 11 Rep Power: 13	Dear. ICEMers Please see if the low mesh quality is from O-grid and the number of nodes. Could you suggest the way to improve mesh quality on balance? You can check the mesh quality by entering the link as below. http://blog.naver.com/4138761/220372464061 Thank you.

May 28, 2015, 11:02		#2
FJSJ Senior Member Javi Join Date: Jan 2013 Posts: 276 Rep Power: 16	Hi Hyowon, I can not see the pictures very well to be honest. However, try to evaluate 3x3x3 determinant instead of 2x2x2 for 3D models and, at the same time, having a look at the bottom face I think you have not a good o-block association. Can you share your project file? catalysthw likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[TGrid] How can I improve mesh quality in TGrid?	hasanifte	ANSYS Meshing & Geometry	0	April 1, 2015 21:27
[ICEM] PistonVale tutorial - issues about mesh quality	Andrea1984	ANSYS Meshing & Geometry	5	October 11, 2013 10:30
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55