[Orb]

I am following along the 3 part tutorial on meshing an airfoil using ICEM CFD with a macro as here: http://www.youtube.com/watch?v=6wQPeBpvwCk

I do not understand how the edges are matched during the "Fastforward" part in the video to capture the airfoil curve (starting around 1:05). Can someone help me make this work with my model? Thanks much.

[farzinkhan]

Originally Posted by Orb

I am following along the 3 part tutorial on meshing an airfoil using ICEM CFD with a macro as here: http://www.youtube.com/watch?v=6wQPeBpvwCk

I do not understand how the edges are matched during the "Fastforward" part in the video to capture the airfoil curve (starting around 1:05). Can someone help me make this work with my model? Thanks much.

hello everybody
in the ANSYS ICEM i have a problem too!
i mesh the airfoil and export msh file but all of boundary define as one edge and i cant specify the boundary condition!
how i can separate them?
thanks!

[mechiebud]

Originally Posted by Orb

I am following along the 3 part tutorial on meshing an airfoil using ICEM CFD with a macro as here: http://www.youtube.com/watch?v=6wQPeBpvwCk

I do not understand how the edges are matched during the "Fastforward" part in the video to capture the airfoil curve (starting around 1:05). Can someone help me make this work with my model? Thanks much.

I tried to do as it is shown in the tutorial but in pre mesh instead of getting the grid, I am getting only horizontal lines. Could you please help me out with that?