|
[Sponsors] |
December 15, 2013, 07:33 |
Extrude in ICEM
|
#1 |
Member
Ali Sarami
Join Date: Jun 2010
Posts: 34
Rep Power: 16 |
Dear Friends,
I have a STL format mesh, I import in into ICEM as Geometry and would like to extrude one of its surfaces normal to that surface as a extension of geometry. Would you please help me how to do that? I examined some possibilities in ICEM but some of them wanted me to define a direction and it is hard because my geometry is complex, I just would like to extrude in normal direction, I also used mesh extrude but the results was very bad. Cheers |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM CFD 5.0 - 2D to 3D Mesh Extrude | James Date | CFX | 7 | October 22, 2013 03:46 |
[Gmsh] Cannot get the right mesh from gmsh | JinBiao | OpenFOAM Meshing & Mesh Conversion | 2 | August 31, 2010 04:51 |
[urgent] ICEM: from 2D to 3D using extrude | Hao | CFX | 3 | March 11, 2010 12:01 |
Extrude mesh in ICEM CFD | Susan | CFX | 2 | November 5, 2007 17:10 |
How to extrude 2D Mesh in ICEM CFD? | VSB | CFX | 7 | December 27, 2006 11:58 |