|
[Sponsors] |
plot Cp over curved line in bend wall using fluent or cfd post |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
hesham
Join Date: Jan 2016
Posts: 32
Rep Power: 10 ![]() |
how can i plot Cp over curved line in bend wall using fluent or cfd post like the dashed line in the picture
|
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Md Asif Equbal
Join Date: Aug 2022
Location: India
Posts: 14
Rep Power: 4 ![]() |
Hi hesham.
if you get your solution then please share with me. Becacuse I am also facing problem to draw line a on curved artery for plotting the result along that. Thanks |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
[ICEM] Export ICEM mesh to Gambit / Fluent | romekr | ANSYS Meshing & Geometry | 1 | November 26, 2011 12:11 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |