 |
 |
 |
|
|
|
[Sponsors] | ||||
September 30, 2024, 18:54
|
XY axis independent
|
#1 |
|
New Member
Renato Trono Figueras
Join Date: Sep 2024
Posts: 1
Rep Power: 0  |
Hi all,
For a 2D plot, I am trying to set the XY axis to be independent and to have the view set to "Data Fit" automatically when tecplot is opened. Right now, I have to do this manually every time and it gets really annoying. To do this, I modified both tecplot.cfg and tecplot.mcr, adding the following commands: $!XYLINEAXIS AXISMODE = INDEPENDENT $!VIEW DATAFIT However, it does not have any effect. I know though that these configuration files are being read by tecplot because other commands do have effects. Any suggestions? Thanks in advance |
|
|
|
|
 |
| Tags |
| axis, command, configuration file, independent, macro |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Continuity Error: Mass Inflow/Outflow | Tiffany | OpenFOAM Running, Solving & CFD | 4 | August 2, 2024 13:35 |
| The CoP Does not exist: Validating Aerodynamic forces through a "line of action" | ds4719 | Main CFD Forum | 14 | February 18, 2022 19:05 |
| [blockMesh] Wierd behaviour of blockMesh creating axis in wedge | rcastilla | OpenFOAM Meshing & Mesh Conversion | 1 | December 4, 2018 07:24 |
| [Other] dynamic Mesh with angular velocity not parallel to x axis | donQi | OpenFOAM Meshing & Mesh Conversion | 5 | October 3, 2014 00:19 |
| Axis treatment in axisymmetrical problem | Jakob1 | OpenFOAM Pre-Processing | 2 | August 25, 2014 04:09 |
Linear Mode
