TecPlot: How to view every 4th grid point of mesh?

ronithstanly · September 24, 2020, 16:39

Hi,

Now when I take a 2D slice and then visualize the mesh on it (Slices>Details>Other>Show Mesh), I see a very black slice because of the fine mesh.
Can someone tell me how to skip every 4th grid point (or similar) on this slice?

I also tried this solution (http://www.tecplottalk.com/forums/viewtopic.php?t=1188) to extract a sub-zone by skipping points, but the extracted sub-zone did not appear in the list of zones, so I could not select it to be visualized.

Can someone please help me?

Thanks,
Ronith

novedevon · September 25, 2020, 18:55

Slices are an extracted surface that will be a FE zone and you can't really skip values with a FE zone.

ronithstanly · September 25, 2020, 19:00

Hi novedevon,

Thanks for your answer.

So are you aware of any other way to skip grid points and to visualize it?
I am fine even if it is not visualized on a slice.

September 24, 2020, 16:39	TecPlot: How to view every 4th grid point of mesh?	#1
ronithstanly New Member Ronith Stanly Join Date: Mar 2017 Location: Sweden Posts: 24 Rep Power: 9	Hi, Now when I take a 2D slice and then visualize the mesh on it (Slices>Details>Other>Show Mesh), I see a very black slice because of the fine mesh. Can someone tell me how to skip every 4th grid point (or similar) on this slice? I also tried this solution (http://www.tecplottalk.com/forums/viewtopic.php?t=1188) to extract a sub-zone by skipping points, but the extracted sub-zone did not appear in the list of zones, so I could not select it to be visualized. Can someone please help me? Thanks, Ronith

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 06:38
[Commercial meshers] Mesh conversion from Tecplot format - help	atmcfd	OpenFOAM Meshing & Mesh Conversion	11	February 22, 2014 07:34
[blockMesh] error EOF in blockMesh	Ahmed Khattab	OpenFOAM Meshing & Mesh Conversion	7	May 17, 2012 01:37
[ICEM] How to demonstrate mesh every 4th point	ringtail	ANSYS Meshing & Geometry	0	November 24, 2010 10:58
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

September 25, 2020, 18:55		#2
novedevon Member Join Date: May 2013 Posts: 61 Rep Power: 13	Slices are an extracted surface that will be a FE zone and you can't really skip values with a FE zone.

September 25, 2020, 19:00		#3
ronithstanly New Member Ronith Stanly Join Date: Mar 2017 Location: Sweden Posts: 24 Rep Power: 9	Hi novedevon, Thanks for your answer. So are you aware of any other way to skip grid points and to visualize it? I am fine even if it is not visualized on a slice.