|
[Sponsors] |
July 18, 2016, 08:43 |
Isosurface using multiple zones
|
#1 |
New Member
Join Date: Oct 2014
Posts: 1
Rep Power: 0 |
Hello everybody,
I have an issue with visualizing isosurfaces with Tecplot from a boundary layer stability calculation. For performance reasons, I split the calculations in separat 2D calculations which I would then like to visualize combined in Tecplot. Unfortunately, when loading each 2D file into Tecplot, they obviously appear as separat zones and isosurfaces are not possible. Does anyone know how to solve this by either merging the zones or "tell" tecplot to do isosurfaces using multiple zones? Thank you so much in advance. Fabian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to create multiple fluid zones and an interface | josephmp | FLUENT | 15 | April 18, 2021 00:28 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Multiple Zones in Ansys CFX 14.5 | r.mojtaba | CFX | 3 | July 28, 2013 07:31 |
OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 12:21 |
Multiple Fluid Zones | Naghman Khan | FLUENT | 3 | August 3, 2007 07:23 |