Forces and Moments over a 2D slice

Hybrid · April 21, 2016, 01:50

Hi,

I made a slice of a wing section along the span (becomes 2D airfoil). Now I would like to integrate/wish to calculate forces and moments on that sliced @D section.

How can I do that?

scott_rumage · April 22, 2016, 11:52

This calculation is performed via the "Analyze" section of Tecplot 360 (found on the top menu bar). I would recommend a thorough reading of the Tecplot 360 manual's chapter 21 titled "CFD Data Analysis" (page 303) to learn how to do this work. Here is a link to the manual: http://download.tecplot.com/360/curr...ers_manual.pdf .

Ali, I do recall that you have had an issue with downloading from Tecplot's web-site in the past, but that web-site is active and so the issue is probably on your end.

I note that you are located in Pakistan. If your Tecplot license is under maintenance support, you can also contact Tecplot's distributor Genias Graphics www.genias-graphics.de for assistance in answering this question.

Good luck,
Scott

April 21, 2016, 01:50	Forces and Moments over a 2D slice	#1
Hybrid Senior Member Ali Join Date: Jan 2012 Location: Pakistan Posts: 134 Rep Power: 16	Hi, I made a slice of a wing section along the span (becomes 2D airfoil). Now I would like to integrate/wish to calculate forces and moments on that sliced @D section. How can I do that? __________________ Best Regards Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ensight: Visualizing forces and moments	David	EnSight	3	December 19, 2012 14:47
Workbench 12.1 reaction forces and moments in response spectrum	KOHCTPYKTOP	ANSYS	0	November 12, 2011 05:42
forces and moments	nico	Main CFD Forum	0	January 28, 2008 08:25
Compute CEs from moments and forces	nico	Main CFD Forum	1	August 6, 2007 20:19
Hydrodynamic forces and moments on submarines	Peo Hedin	Main CFD Forum	2	July 20, 1999 03:53

April 22, 2016, 11:52		#2
scott_rumage Senior Member Scott Rumage Join Date: May 2009 Location: Seattle, WA Posts: 152 Rep Power: 17	This calculation is performed via the "Analyze" section of Tecplot 360 (found on the top menu bar). I would recommend a thorough reading of the Tecplot 360 manual's chapter 21 titled "CFD Data Analysis" (page 303) to learn how to do this work. Here is a link to the manual: http://download.tecplot.com/360/curr...ers_manual.pdf . Ali, I do recall that you have had an issue with downloading from Tecplot's web-site in the past, but that web-site is active and so the issue is probably on your end. I note that you are located in Pakistan. If your Tecplot license is under maintenance support, you can also contact Tecplot's distributor Genias Graphics www.genias-graphics.de for assistance in answering this question. Good luck, Scott